This system is in a boat and consists of the following:
Kicker KMT6 Long Range Speaker System
LINK
These are listed as a Frequency Response Range of 50-21k.
They are powered by a Kicker ZX 200.2 AMP.
There are also 4 Kicker KM-620 Coaxial Drivers inside the boat.
These are listed as a Frequency Response Range of 35-21k.
They are powered by a Kicker ZX 200.4 AMP.
There are the 2 Kicker 10L5 subs being powered by a Kicker ZX-750.1
These are dual 2 ohm subs wired as a 2 ohm load to the AMP.
There is a Sony Head Unit feeding a Kicker KQ5 EQ with
5 frequency ranges:
Bass 40Hz-90Hz
Midbass 125Hz-250Hz
Lower Midrange 300Hz-750Hz
Upper Midrange 1kHz-4kHz
Treble 6kHz-20kHz
Cut/Boost ±12dB
Input Sensitivity 950mV-9.6V
Output Level 7.0Vrms
The question is now that I have everything powered up and playing how do I begin to set everything?
Should AMP 1 and AMP 2 be set to HI-PASS or FULL RANGE?
Also what are some good basic starting points for setting the EQ?
The instructions for setting the gains on the EQ are bit confusing but I think I have that part done correctly. Getting the correct frequencies to the speakers seems a bit tougher. Any help or direction would be greatly appreciated.
Thanks.